Experiments are conducted on a flat recovery wall downstream of sustained concave curvature in the presence of high free-stream turbulence (TI ∼ 8%). This flow simulates some of the features of the flow on the latter parts of the pressure surface of a gas turbine airfoil. The combined effects of concave curvature and TI, both present in the flow over a turbine airfoil, have so far been little studied. Computation of such flows with standard turbulence closure models has not been particularly successful. This experiment attempts to characterize the turbulence characteristics of this flow. In the present study, a turbulent boundary layer grows from the leading edge of a concave wall, then passes onto a downstream flat wall. Results show that turbulence intensities increase profoundly in the outer region of the boundary layer over the recovery wall. Near-wall turbulent eddies appear to lift off the recovery wall and a “stabilized” region forms near the wall. In contrast to a low-free-stream turbulence intensity flow, turbulent eddies penetrate the outer parts of the “stabilized” region where sharp velocity and temperature gradients exist. These eddies can more readily transfer momentum and heat. As a result, skin friction coefficients and Stanton numbers on the recovery wall are 20 and 10 percent, respectively, above their values in the low-free-stream turbulence intensity case. Stanton numbers do not undershoot flat-wall expectations at the same Reδ2 values as seen in the low-TI case. Remarkably, the velocity distribution in the core of the flow over the recovery wall exhibits a negative gradient normal to the wall under high-free-stream turbulence intensity conditions. This velocity distribution appears to be the result of two effects: (1) cross transport of kinetic energy by boundary work in the upstream curved flow and (2) readjustment of static pressure profiles in response to the removal of concave curvature.

Issue Section:
Research Papers
Topics:
Boundary layers, Turbulence, Flow (Dynamics), Eddies (Fluid dynamics), Airfoils, Pressure, Boundary layer turbulence, Computation, Gas turbines, Heat, Kinetic energy, Momentum, Skin friction (Fluid dynamics), Temperature gradient, Turbines
1.
Blair
M. F.
,
1983
, “
Influence of Free-Stream Turbulence on Turbulent Boundary Layer Heat Transfer and Mean Profile Development, Part II—Analysis of Results
,”
ASME Journal of Heat Transfer
, Vol.
105
, pp.
41
–
47
.
2.
Brown, A., and Burton, R. C., 1977, “The Effects of Free-Stream Turbulence Intensity and Velocity Distribution on Heat Transfer to Curved Surfaces,” ASME Paper No. 77-GT-48.
3.
Eckert
E. R. G.
,
1987
, “
Cross Transport of Energy in Fluid Streams
,”
Wa¨rme-und Stoffu¨bertragung
, Vol.
21
, pp.
73
–
81
.
4.
Feiler, C. E., and Yeager, E. B., 1962, “Effect of Large-Amplitude Oscillations on Heat Transfer,” NASA Tech. Report R-142.
5.
Hancock
P. E.
, and
Bradshaw
P.
,
1983
, “
The Effect of Free-Stream Turbulence on Turbulent Boundary Layers
,”
ASME Journal of Fluids Engineering
, Vol.
105
, pp.
284
–
289
.
6.
Kays, W. M., and Moffat, R. J., 1975, “The Behavior of Transpired Turbulent Boundary Layers,” Report HMT-20, Thermosciences Division, Department of Mechanical Engineering, Stanford University, CA.
7.
Kestin, J., 1966, “The Effects of Free-Stream Turbulence on Heat Transfer Rates,” Advances in Heat Transfer, Vol. 3, T. F. Irvine, Jr., and J. P. Hartnett, eds., Academic Press, London.
8.
Kestoras
M. D.
, and
Simon
T. W.
,
1992
, “
Hydrodynamic and Thermal Measurements in a Turbulent Boundary Layer Recovering From Concave Curvature
,”
ASME JOURNAL OF TURBOMACHINERY
, Vol.
114
, No.
4
, pp.
891
–
898
.
9.
Kestoras, M. D., 1993, “Heat Transfer and Fluid Mechanics Measurements in a Turbulent Boundary Layer Recovering From Concave Curvature,” Ph.D. Thesis, University of Minnesota.
10.
Kim
J.
,
Simon
T. W.
, and
Russ
S. G.
,
1991
, “
Free-Stream Turbulence and Concave Curvature Effects on Heated, Transitional Boundary Layers
,”
ASME Journal of Heat Transfer
, Vol.
114
, No.
2
, pp.
339
–
347
.
11.
Nakano, S., Takahashi, A., Shizawa, T., and Honami, S., 1981, “Effects of Stable and Unstable Free-Streams on a Turbulent Flow Over a Concave Surface,” Proc. 3rd Symposium on Turbulent Shear Flows, Davis, CA.
12.
O’Brien, J. E., and vanFossen, G. J., 1985, “The Influence of Jet Grid Turbulence on Heat Transfer From the Stagnation Region of a Cylinder in Cross Flow,” ASME Paper No. 85-HT-58.
13.
Russ, S. G., 1989, “The Generation and Measurement of Turbulent Flow Fields,” MSME Thesis, Dept. of Mech. Eng., University of Minnesota.
14.
Simonich
J. C.
, and
Bradshaw
P.
,
1978
, “
Effect of Free-Stream Turbulence on Heat Transfer through a Turbulent Boundary Layer
,”
ASME Journal of Heat Transfer
, Vol.
100
, pp.
671
–
677
.
15.
Wang, T., 1984, “An Experimental Investigation of Curvature and Freestream Turbulence Effects on Heat Transfer and Fluid Mechanics in Transition Boundary Layer Flows,” PhD Thesis, University of Minnesota.
16.
You
S. M.
,
Simon
T. W.
, and
Kim
J.
,
1989
, “
Free-Stream Turbulence Effects on Convex-Curved Turbulent Boundary Layers
,”
ASME Journal of Heat Transfer
, Vol.
111
, pp.
66
–
72
.
This content is only available via PDF.
Copyright © 1995
 by The American Society of Mechanical Engineers
You do not currently have access to this content.