The development and performance of a full-scale carbon particle cloud generator together with the evaluation of nine commercial carbon blacks is reported. Large variations were found in the dispersability and settling properties of the investigated powders. Scanning electron microscope analysis of cloud samples from different powders showed unequal state of agglomeration and particle size. The particle population distribution of the most suitable powder was determined, showing that the particle cloud consisted of 99.8% spheroid primary particles (25–570 nm dia) and 0.2% large irregularly shaped agglomerates. Although the numerical fraction of the agglomerates was only 0.2%, they contributed 40% to the cloud’s geometrical cross section. Significant variations in the population distribution were found from different batches of the same particle powder. The developed full-scale particle generator was capable of sustained operation, creating a particle cloud with an extinction coefficient exceeding 40m−1 at a nominal flow rate of 25 SLPM. The dispersal efficiency of the system with the optimal ejection nozzle was 25%, compared to less than 1% for free ejection. The particle dispersal rate was 30 g/hr at 25 SLPM at an evacuation efficiency of 87%. Specific extinction cross-sections of 5.8m2/g were measured for particle mass loading higher than 2g/m3.

Issue Section:
Technical Papers
Keywords:
solar absorber-convertors, solar heating, carbon, powders, scanning electron microscopy
Topics:
Carbon, Particulate matter, Generators
1.
Hunt, A. J., 1982, “Solar Testing of the Small Particle Heat Exchanger (SPHER),” Berkley California, Report LBL-16497.
2.
Abdelrahman
,
M.
,
Fumeaux
,
P.
, and
Suter
,
P.
,
1979
, “
Study of Solid-Gas Suspension used for Direct Absorption of Concentrated Solar Radiation
,”
Sol. Energy
,
22
, pp.
45
–
48
.
3.
Hunt, A. J., 1979, “A New Solar Receiver Utilizing a Small Particle Heat Exchanger,” Proc. of 14th Int. Society of Energy Conversion Engineering Conf., 1, pp. 159–163.
4.
Miller, F. J., 1988, “Radiative Heat Transfer in a Flowing Gas Particle Mixture,” Ph.D. thesis, Univ. of California, Berkley.
5.
Bohren, C. F., and Huffman, D. K., 1983, Absorption and Scattering of Light by Small Particles, Wiley, New York.
6.
Krishnan, S. S., Lin, K.-C., and Faeth, G. M., 2000, “Extinction and Scattering of Soot Emitted from Turbulent Diffusion Flames for Wavelengths of 250–5200 nm,” Proc. of 34th National Heat Transfer Conf., Pittsburgh, PA.
7.
Oman
,
J.
, and
Novak
,
P.
,
1996
, “
Volumetric Absorption in Gas-Properties of Particles and Particle-Gas Suspensions
,”
Sol. Energy
,
56
(
6
), pp.
597
–
605
.
8.
Bertocchi, R., Kribus, A., and Karni, J., 2001, “Optical Properties of a Stable Polydisperse Carbon Particle Cloud,” ASME J. Heat Transfer (submitted).
9.
Stone, J. N., 1997, “Cyclone Design and Analysis,” www.mnsi.net/∼pas/esco.htm, Esco Engineering, Kingsville, Ontario, Canada.
10.
Taylor, J. R., 1982, An Introduction to Error Analysis, University Science Books.
Copyright © 2002
 by ASME
You do not currently have access to this content.