The stresses and strains induced in a composite material when subjected to mechanical loads are shown to be strongly influenced by prior exposure to both temperature changes (e.g., cooldown from the curing temperature) and moisture absorption (e.g., even normal exposure to ambient conditions after cure). These environmental effects are in turn influenced by normal variabilities in the basic properties of the composite constituents. Using a recently developed finite element numerical model of composite material inelastic hygrothermal response, variations in stresses and strains are predicted as a function of variations in constituent material properties. A typical graphite/epoxy composite is selected for detailed study. This system is of particular interest because of the anisotropic nature of graphite fibers, and the strong temperature and moisture dependence of the epoxy matrix. Specific fiber property variations considered include transverse modulus, major Poisson’s ratio, and in-plane Poisson’s ratio. Results are compared with those obtained for an isotropic fiber composite.
Skip Nav Destination
Article navigation
January 1978
Research Papers
The Influence of Material Variability on the Predicted Environmental Behavior of Composite Materials
Donald F. Adams,
Donald F. Adams
Department of Mechanical Engineering, University of Wyoming, Laramie, Wy.
Search for other works by this author on:
A. Keith Miller
A. Keith Miller
Department of Mechanical Engineering, University of Wyoming, Laramie, Wy.
Search for other works by this author on:
Donald F. Adams
Department of Mechanical Engineering, University of Wyoming, Laramie, Wy.
A. Keith Miller
Department of Mechanical Engineering, University of Wyoming, Laramie, Wy.
J. Eng. Mater. Technol. Jan 1978, 100(1): 77-83 (7 pages)
Published Online: January 1, 1978
Article history
Received:
March 30, 1977
Revised:
July 12, 1977
Online:
August 17, 2010
Citation
Adams, D. F., and Miller, A. K. (January 1, 1978). "The Influence of Material Variability on the Predicted Environmental Behavior of Composite Materials." ASME. J. Eng. Mater. Technol. January 1978; 100(1): 77–83. https://doi.org/10.1115/1.3443454
Download citation file:
Get Email Alerts
Cited By
Related Articles
Prediction of Extent of Heat Affected Zone in Laser Grooving of Unidirectional Fiber-Reinforced Plastics
J. Eng. Mater. Technol (October,1998)
Calculation of the Response of a Composite Plate to Localized Dynamic Surface Loads Using a New Wave Number Integral Method
J. Appl. Mech (January,2005)
Electric Resistive Heat Curing of the Fiber-Matrix Interphase in Graphite/Epoxy Composites
J. Mech. Des (March,1993)
Use of an Advanced Shear-Lag Model to Obtain the Optimum Internal Damping in Short-Fiber Composites
Appl. Mech. Rev (November,1989)
Related Chapters
Microcrack Growth in Graphite Fiber-Epoxy Resin Systems During Compressive Fatigue
Fatigue of Composite Materials
Characterization of Ultra-High Temperature and Polymorphic Ceramics
Advanced Multifunctional Lightweight Aerostructures: Design, Development, and Implementation
Temperature Dependence of the Complex Modulus for Fiber-Reinforced Materials
Composite Reliability