1-17 of 17
Keywords: diffusion
Close
Sort by
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. August 2011, 133(8): 082101.
Published Online: April 8, 2011
... where the combination of high stress and high temperature led to higher rates of oxygen diffusion and subsequent oxidation of grain boundary carbides. Hafnium carbide precipitates along the grain boundaries expanded as they converted into hafnium oxide, thus further increasing the stress...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. February 2011, 133(2): 022101.
Published Online: October 29, 2010
...Mitsutoshi Okada; Tohru Hisamatsu; Terutaka Fujioka A CoNiCrAlY-coated blade of an in-service gas turbine is analyzed, and a diffusion layer is formed along the boundary between the coating and the substrate due to the interdiffusion in the middle and tip of the blade. Such a layer is not observed...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. December 2010, 132(12): 122803.
Published Online: August 30, 2010
... and combustion processes. Based on the idea of enhancing diffusion combustion at the later stage of the combustion period, three different bowl geometries, namely, bowl 1 (baseline), bowl 2, and bowl 3 were selected and investigated. All the other relevant parameters, namely, compression ratio, maximum diameter...
Journal Articles
Publisher: ASME
Article Type: Technical Briefs
J. Eng. Gas Turbines Power. November 2010, 132(11): 114502.
Published Online: August 10, 2010
...S. Chakrabarti; S. Rao; D. K. Mandal In this paper, the results of numerical simulation on the performance of a sudden expansion with fence viewed as a diffuser are presented. The two-dimensional steady differential equations for conservation of mass and momentum have been solved using the semi...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. July 2010, 132(7): 071504.
Published Online: April 14, 2010
...-hydrogen fuel using a water-gas shift reactor and subsequent CO 2 separation. The IGCC’s air separation unit produces a volume of N 2 roughly equivalent to the volume of H 2 in the gasifier product stream, which can be used to help reduce peak flame temperatures and NO x in the diffusion flame combustor...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. June 2010, 132(6): 061507.
Published Online: March 30, 2010
... gas is supplied to the combustor independent of fuel and air supplies. In such cases, classical approaches become quite time-consuming. In the present paper, a new three-stream flamelet model is presented, which is essentially an extension of the two-stream flamelet model for diffusion flames. Key...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. February 2010, 132(2): 022103.
Published Online: November 5, 2009
... and (ii) it provides an additional resistance to oxidation. It was the objective of this study to develop an understanding of the role of platinum in bond coats of the diffusion-type deposited on a nickel-based superalloy. Two Pt-containing bond coats were included in the study: (i) a platinum-aluminide...
Journal Articles
Publisher: ASME
Article Type: Technical Briefs
J. Eng. Gas Turbines Power. September 2009, 131(5): 054501.
Published Online: May 22, 2009
...M. Madanmohan; S. Pandey; A. Kushari; K. Ramamurthi This paper describes the results of an experimental study to understand the influence of inlet flow disturbances on the dynamics of combustion process in bluff body stabilized diffusion flames of liquid petroleum gas and air. The results show...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Eng. Gas Turbines Power. May 2009, 131(3): 031501.
Published Online: January 29, 2009
...Bijan Kumar Mandal; Amitava Sarkar; Amitava Datta A numerical investigation of the transient development of flame and soot distributions in a laminar axisymmetric coflowing diffusion flame of methane in air has been carried out considering the air preheating effect. The gas phase conservation...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. October 2007, 129(4): 1072–1078.
Published Online: February 9, 2007
.... The theoretical work was also conducted for further investigation of the effects of the above-mentioned parameters on PM filtration. These results indicated that diffusion filtration was the dominant mechanism for PM filtration under the conditions of this study and that the decrease in PM filtration efficiency...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. January 2007, 129(1): 2–12.
Published Online: September 28, 2005
... emissions as compared to gas turbines with a single combustor and a single diffusion burner for liquid and gaseous fuel have been achieved with burners with extended premixing sections and with multi-injection burners for annular combustors. Between 1990 and 2005, burners with short but effective premixing...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. April 2005, 127(2): 301–306.
Published Online: April 15, 2005
...J. Eckstein; E. Freitag; C. Hirsch; T. Sattelmayer; R. von der Bank; T. Schilling The low-frequency response of the spray from a generic airblast diffusion burner with a design typical of an engine system has been investigated as part of an experimental study to describe the combustion oscillations...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. October 2003, 125(4): 879–884.
Published Online: November 18, 2003
... a diffusion flame or partially premixed pilot in an otherwise DLN combustor can enable operation at conditions with substantially reduced NO x emissions. Nominal Taurus 70 full-load combustor operating conditions Baseload inlet temperature 705 K (432°C/810°F) Baseload inlet pressure 1.7...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. July 2003, 125(3): 686–692.
Published Online: August 15, 2003
... maintenance is an added benefit. A prototype membrane filter module for on-line removal of dissolved oxygen, which would otherwise react to form coke precursors, was constructed and successfully demonstrated. The fuel flows over the membrane, while oxygen diffuses through it at a rate that is proportional...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Eng. Gas Turbines Power. January 2000, 122(1): 50–54.
Published Online: October 20, 1999
...N. S. Cheruvu; K. S. Chan; G. R. Leverant Cyclic oxidation behavior of aluminide, platinum modified aluminide, and MCrAlY coatings has been investigated at three temperatures. Aluminide and platinum modified coatings were deposited on GTD 111 material using an outward diffusion process. CoCrAlY...
Journal Articles